diff --git a/include/configs/a3m071.h b/include/configs/a3m071.h
index df3b4ae..d8559d8 100644
--- a/include/configs/a3m071.h
+++ b/include/configs/a3m071.h
@@ -26,15 +26,22 @@
 #define CONFIG_MPC5200
 #define CONFIG_MPC5xxx		1	/* This is an MPC5xxx CPU */
 #define CONFIG_A3M071			/* ... on A3M071 board */
-#define CONFIG_MPC5200_DDR		/* ... use DDR RAM	*/
 
 #define	CONFIG_SYS_TEXT_BASE	0x01000000	/* boot low for 32 MiB boards */
 
+#define CONFIG_SPL_TARGET	"u-boot-img.bin"
+
 #define CONFIG_SYS_MPC5XXX_CLKIN	33000000 /* ... running at 33MHz */
 
 #define CONFIG_MISC_INIT_R
 #define CONFIG_SYS_LOWBOOT		/* Enable lowboot	*/
 
+#ifdef CONFIG_A4M2K
+#define CONFIG_HOSTNAME		a4m2k
+#else
+#define CONFIG_HOSTNAME		a3m071
+#endif
+
 /*
  * Serial console configuration
  */
@@ -50,9 +57,6 @@
 
 #define CONFIG_CMD_BSP
 #define CONFIG_CMD_CACHE
-#define CONFIG_CMD_DATE
-#define CONFIG_CMD_EEPROM
-#define CONFIG_CMD_I2C
 #define CONFIG_CMD_MII
 #define CONFIG_CMD_REGINFO
 
@@ -61,7 +65,11 @@
  */
 #define CONFIG_SYS_IPBCLK_EQUALS_XLBCLK		/* define for 133MHz speed */
 /* define for 66MHz speed - undef for 33MHz PCI clock speed */
+#ifdef CONFIG_A4M2K
+#define CONFIG_SYS_PCICLK_EQUALS_IPBCLK_DIV2
+#else
 #undef CONFIG_SYS_PCICLK_EQUALS_IPBCLK_DIV2
+#endif
 
 /* pass open firmware flat tree */
 #define CONFIG_OF_LIBFDT
@@ -76,33 +84,10 @@
 #define OF_STDOUT_PATH		"/soc5200@f0000000/serial@2000"
 
 /*
- * I2C configuration
- */
-#define CONFIG_HARD_I2C				/* I2C with hardware support */
-#define CONFIG_SYS_I2C_MODULE		2	/* Select I2C module #1 or #2 */
-
-#define CONFIG_SYS_I2C_SPEED		100000 /* 100 kHz */
-#define CONFIG_SYS_I2C_SLAVE		0x7F
-
-/*
- * EEPROM configuration
- */
-#define CONFIG_SYS_I2C_EEPROM_ADDR		0x53
-#define CONFIG_SYS_I2C_EEPROM_ADDR_LEN		2
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS	6
-#define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS	10
-
-/*
- * RTC configuration
- */
-#define CONFIG_RTC_PCF8563
-#define CONFIG_SYS_I2C_RTC_ADDR		0x51
-
-/*
  * NOR flash configuration
  */
 #define CONFIG_SYS_FLASH_BASE		0xfc000000
-#define CONFIG_SYS_FLASH_SIZE		0x01000000
+#define CONFIG_SYS_FLASH_SIZE		0x02000000
 #define CONFIG_ENV_ADDR			(CONFIG_SYS_FLASH_BASE + 0x40000)
 
 #define CONFIG_SYS_MAX_FLASH_BANKS	1
@@ -153,7 +138,11 @@
  */
 #define CONFIG_MPC5xxx_FEC
 #define CONFIG_MPC5xxx_FEC_MII100
+#ifdef CONFIG_A4M2K
+#define CONFIG_PHY_ADDR			0x01
+#else
 #define CONFIG_PHY_ADDR			0x00
+#endif
 
 /*
  * GPIO configuration
@@ -166,19 +155,23 @@
  *          2 means fpga ok
  */
 
+#ifdef CONFIG_A4M2K
+#define CONFIG_SYS_GPS_PORT_CONFIG	0x0005C805
+#else
 /* for failsave-level 0 - full failsave */
 #define CONFIG_SYS_GPS_PORT_CONFIG	0x1005C005
 /* for failsave-level 1 - only digiboard ok */
 #define CONFIG_SYS_GPS_PORT_CONFIG_1	0x1005C005
 /* for failsave-level 2 - all ok */
 #define CONFIG_SYS_GPS_PORT_CONFIG_2	0x1005C005
+#endif
 
 /*
  * Configuration matrix
  *                        MSB                          LSB
- * failsave 0  0x1005C005  00010000000001011100000001100101  ( full failsave )
- * failsave 1  0x1005C005  00010000000001011100000001100101  ( digib.-ver ok )
- * failsave 2  0x1005C005  00010000000001011100000001100101  ( all ok )
+ * failsave 0  0x1005C005  00010000000001011100000000000101  ( full failsave )
+ * failsave 1  0x1005C005  00010000000001011100000000000101  ( digib.-ver ok )
+ * failsave 2  0x1005C005  00010000000001011100000000000101  ( all ok )
  *                         || ||| ||  |   ||| |   |   |   |
  *                         || ||| ||  |   ||| |   |   |   |  bit rev name
  *                         ++-+++-++--+---+++-+---+---+---+-  0   31 CS1
@@ -254,30 +247,47 @@
 #define CONFIG_SYS_BOOTCS_SIZE		CONFIG_SYS_FLASH_SIZE
 #define CONFIG_SYS_CS0_START		CONFIG_SYS_FLASH_BASE
 #define CONFIG_SYS_CS0_SIZE		CONFIG_SYS_FLASH_SIZE
+
+#ifdef CONFIG_A4M2K
+/* external MRAM */
+#define CONFIG_SYS_CS1_START		0xf1000000
+#define CONFIG_SYS_CS1_SIZE		(512 << 10)	/* 512KiB MRAM */
+#endif
+
 #define CONFIG_SYS_CS2_START		0xe0000000
 #define CONFIG_SYS_CS2_SIZE		0x00100000
 
-/* FPGA slave io (512kiB) - see ticket #66 */
+/* FPGA slave io (512kiB / 1MiB) - see ticket #66 */
 #define CONFIG_SYS_CS3_START		0xE9000000
+#ifdef CONFIG_A4M2K
+#define CONFIG_SYS_CS3_SIZE		0x00100000
+#else
 #define CONFIG_SYS_CS3_SIZE		0x00080000
+#endif
 /* 00000000 00110010 1 0 1 1 10 01 00 00 0 0 0 0  = 0x0032B900 */
 #define CONFIG_SYS_CS3_CFG		0x0032B900
 
+#ifndef CONFIG_A4M2K
 /* Diagnosis Interface - see ticket #63 */
 #define CONFIG_SYS_CS4_START		0xEA000000
 #define CONFIG_SYS_CS4_SIZE		0x00000001
 /* 00000000 00000010 1 0 1 1 10 01 00 00 0 0 0 0  = 0x0002B900 */
 #define CONFIG_SYS_CS4_CFG		0x0002B900
+#endif
 
-/* FPGA master io (64kiB) - see ticket #66 */
+/* FPGA master io (64kiB / 1MiB) - see ticket #66 */
 #define CONFIG_SYS_CS5_START		0xE8000000
+#ifdef CONFIG_A4M2K
+#define CONFIG_SYS_CS5_SIZE		0x00100000
+#else
 #define CONFIG_SYS_CS5_SIZE		0x00010000
+#endif
 /* 00000000 00110010 1 0 1 1 10 01 00 00 0 0 0 0  = 0x0032B900 */
 #define CONFIG_SYS_CS5_CFG		0x0032B900
 
 #ifdef CONFIG_SYS_PCICLK_EQUALS_IPBCLK_DIV2	/* for pci_clk  = 66 MHz */
 #define CONFIG_SYS_BOOTCS_CFG		0x0006F900
-#define CONFIG_SYS_CS1_CFG		0x0004FB00
+#define CONFIG_SYS_CS1_CFG		0x0008FD00
 #define CONFIG_SYS_CS2_CFG		0x0006F90C
 #else	/* for pci_clk = 33 MHz */
 #define CONFIG_SYS_BOOTCS_CFG		0x0002F900
@@ -311,17 +321,25 @@
 #define CONFIG_SYS_OS_BASE	0xfc080000
 #define CONFIG_SYS_FDT_BASE	0xfc060000
 
-#define xstr(s)	str(s)
-#define str(s)	#s
-
 #define	CONFIG_EXTRA_ENV_SETTINGS					\
+	"hostname=" __stringify(CONFIG_HOSTNAME) "\0"			\
 	"netdev=eth0\0"							\
 	"verify=no\0"							\
+	"loadaddr=200000\0"						\
+	"kernel_addr=" __stringify(CONFIG_SYS_OS_BASE) "\0"		\
+	"kernel_addr_r=1000000\0"					\
+	"fdt_addr=" __stringify(CONFIG_SYS_FDT_BASE) "\0"		\
+	"fdt_addr_r=1800000\0"						\
+	"bootfile=" __stringify(CONFIG_HOSTNAME) "/uImage\0"		\
+	"fdtfile=" __stringify(CONFIG_HOSTNAME) "/"			\
+		__stringify(CONFIG_HOSTNAME) ".dtb\0"			\
+	"rootpath=/opt/eldk-5.2.1/powerpc/"				\
+		"core-image-minimal-mtdutils-dropbear-generic\0"	\
 	"consoledev=ttyPSC0\0"						\
 	"nfsargs=setenv bootargs root=/dev/nfs rw "			\
 		"nfsroot=${serverip}:${rootpath}\0"			\
 	"ramargs=setenv bootargs root=/dev/ram rw\0"			\
-	"mtdargs=setenv bootargs root=/dev/mtdblock4 rw rootfstype=jffs2\0"\
+	"mtdargs=setenv bootargs root=/dev/mtdblock4 rw rootfstype=jffs2\0" \
 	"addip=setenv bootargs ${bootargs} "				\
 		"ip=${ipaddr}:${serverip}:${gatewayip}:${netmask}"	\
 		":${hostname}:${netdev}:off panic=1\0"			\
@@ -332,18 +350,18 @@
 	"flash_mtd=run mtdargs addip addtty;"				\
 		"bootm ${kernel_addr} - ${fdtaddr}\0"			\
 	"flash_self=run ramargs addip addtty;"				\
-		"bootm ${kernel_addr} ${ramdisk_addr} ${fdtaddr}\0"	\
-	"net_nfs=sleep 2; tftp ${loadaddr} ${bootfile};"		\
-		"tftp c00000 ${fdtfile};"				\
+		"bootm ${kernel_addr} ${ramdisk_addr} ${fdt_addr}\0"	\
+	"net_nfs=tftp ${kernel_addr_r} ${bootfile};"			\
+		"tftp ${fdt_addr_r} ${fdtfile};"			\
 		"run nfsargs addip addtty;"				\
-		"bootm ${loadaddr} - c00000\0"				\
-	"load=tftp ${loadaddr} u-boot.bin\0"				\
+		"bootm ${kernel_addr_r} - ${fdt_addr_r}\0"		\
+	"load=tftp ${loadaddr} " __stringify(CONFIG_HOSTNAME)		\
+		"/u-boot-img.bin\0"					\
 	"update=protect off fc000000 fc03ffff; "			\
-		"era fc000000 fc03ffff; cp.b ${loadaddr} fc000000 40000\0"\
+		"era fc000000 fc03ffff; cp.b ${loadaddr} fc000000 40000\0" \
 	"upd=run load;run update\0"					\
-	"fdtaddr=" xstr(CONFIG_SYS_FDT_BASE) "\0"			\
-	"fdtfile=dtbFile\0"						\
-	"kernel_addr=" xstr(CONFIG_SYS_OS_BASE) "\0"			\
+	"bootdelay=3\0"							\
+	"bootcmd=run net_nfs\0"						\
 	""
 
 #define CONFIG_BOOTCOMMAND	"run flash_mtd"
@@ -353,6 +371,7 @@
  */
 #define CONFIG_SPL
 #define CONFIG_SPL_FRAMEWORK
+#define CONFIG_SPL_BOARD_INIT
 #define CONFIG_SPL_NOR_SUPPORT
 #define CONFIG_SPL_TEXT_BASE	0xfc000000
 #define	CONFIG_SPL_START_S_PATH	"arch/powerpc/cpu/mpc5xxx"